Sunday, July 20, 2014

How To Go About James Hardie Siding Installation

By Paulette Mason


Most home owners and real estate owners are opting to use wall covers. This is essential ion ensuring that buildings last for a long time and making them look more beautiful. For the real estate sector, using wall covers goes a long way in adding home value. The james hardie siding installation is essential in doping this and it is available in various sizes, shapes and it comes with guidelines on how to install.

There is need to observe safety in a placement excise. There is couple of safety measures that should be put into consideration. Wear a pair of goggles to protect the eyes from damage. A dust cover is vital to protect the one from inhaling harmful dust that may end up causing respiratory diseases. Cover the ears from dust as well as noise from the hammer and cutting tools.

Start with the inspection of this cover. This is to assess the damage that may have been caused during transportation when moving to st louis mo. Make sure that it is dry before placement. This is to prevent rotting before is it nailed on the walls. Carry covers on edge to avoid cases of any breakage. When cutting covers, make sure that it is supported.

Use the correct nail size in the placement excises. Depending on an expert, one may use hand nailing technique or use a pneumatic nail. A pneumatic nail is best when handling fragile covers. Screws may also be used co currently with the nails. This is however dependent on the thickness of these covers. Use stainless steel or hot galvanized nails.

The best position to attach the covers is when the nail is one inch from the cover. Blind nailing is a technique used when the nails are hit from the top. Face nailing is applied at the bottom. Roofing nails are the best for blind nailing while face nailing is good with cover screws. Start by placing the outside and inside edges on the walls.

When nailing, ensure you apply overlap gauges. The gauges are essential in supporting covers especially when working alone. Studs are used on the first row of the nailing procedure. Remember to leave caulking allowance so that it will happen between gaps. You can only use pre drilling nails at the end. Do not forget to knit the joints carefully so that air and water do not penetrate into the building.

Level checkers are used to maintain the lining of rows. This is especially when fixing the down and casement markings. Use the marks at each end. Cut a piece of the plank to make correct gable cuts in the desired angle and label each piece.

Do not forget to place the covers well. This will go a long way in protecting the home from damages. Any defects arising from this procedure might lower the value of your home. Ask from experts on how to go about each procedure.




About the Author:



No comments:

Post a Comment